Home Improvement

Tips and Advice Choosing Bathroom Taps for Your Hom

Google+ Pinterest LinkedIn Tumblr

Choosing bathroom taps, or any other taps for your house can be difficult!   

TAP DESIGN:

Operationally, Tap design consists of three factors:

The number of holes that will need to be in the washbasin/bath/bidet or wall.

 The number of valves directing the stream of water.

 The number of taps (spouts) from which water flows. (i.e., mixer or single )

When choosing your taps, you will need to bear in mind the environment/location where the taps will be set up, as well as the decor/ambiance needed in every room.

TAP STYLES AND FINISHES

As stated previously, we’re spoiled for choice, since there is a range of contemporary taps, modern taps (classic), and designer taps, and conventional taps.  In addition to the layout we then frequently have a choice of color.

A variety of finishes are available that are enameled or metal plated.  Most taps are made from brass, allowing a fantastic quality finish to be applied.  Numerous finishes are available in matt or high gloss including polished chrome brass, silk steel, nickel, and gold.  Technology has enabled cheap bath taps to be available at acceptable quality.

The top end of this marketplace designs are made from solid stainless steel, with a high polished glow or brushed to make a low sheen finish.  The benefit of these is that as a result of being manufactured in stainless steel, they are much harder wearing than their cheaper options, and can even maintain their polish/sheen for more.

The problem in making a fantastic choice is the balance between budget and want!  A minimal budget can drive you in choosing a poorer quality product, leading to the plated finish wearing out sooner rather than later.  Stay in the property for any amount of time? Are you choosing and fitting cheap bath taps to a rental property? Thus do you plan for these are significant choices.

IS THERE ENOUGH WATER PRESSURE FOR YOUR BATHROOM TAPS?

There is nothing worse than not having sufficient pressure to deliver the correct stream of water, to your bath taps, and notably to the shower.

So before choosing your tap, you need to establish what level of pressure you have on your bathroom.  The cause of this is that many bath taps require high pressure to operate properly.

At what pressure is the water delivered to your bathroom?  The rising mains pressure is generally around 2.0 pubs, which can be satisfactory, but it is unlikely that this is supplied direct.  So you have to ensure your water pressure for both hot and cold taps is over 1.0 bar if you choose and install high-pressure taps. If your water pressure is below this, then you have to pick out a minimal pressure tap to operate properly.

Now the hot water from the heating system (boiler) ought to be under high pressure if you have one of the following:

A combination boiler that is included by water and heats the hot water as you use it.

 A gravity fed system with a pump that increases water pressure to more than 1.0 pub A pressurized (unvented) heating system, where the mains cold water right supplies all cold taps but also feeds direct to the hot water cylinder, thereby preserving high pressure.

A general guideline is that only lever mixer taps require high pressure, whereas pillar taps and 2 handled taps that control water circulation (fillers) can operate on low pressure.

If in any doubt about your water pressure levels, either get in touch with your boiler service engineer or discuss it with a proprietary ‘taps’ supplier. You can find them locally or use Google to search online.

Whether you’re interested in modern taps, designer taps, or cheap tub taps, check out locally what is available, but it is then worth searching on the internet for suppliers who may offer a much more competitive cost.  There are great deals out there! And here are a lot of Chandeliers deals.

Write A Comment